|
318_garage
Datum: 06.05.2017
Betrachtungen: 3174
|
318_verdeck_1
The Tent DIDNT hold up, somewhat expected. And of course, the soft top was wet again :-(
Anyways, great opertunity to clean it from all that algae and lichen
Datum: 07.05.2017
Betrachtungen: 6537
|
318_verdeck_2
Some success: the soft top is working on automatic again... sadly not all the way. This is the firt point of binding. Have to push the last "gantry" bar to the front of the car for the lid to open fully and the top to move further back.
Datum: 07.05.2017
Betrachtungen: 3897
|
|
318_verdeck_3
Second point of binding. have to grab the front part and push it backwards a few cm, then the motors catch again and it moves all the way into the well.
Datum: 07.05.2017
Betrachtungen: 4002
|
318_verdeck_4
last point of binding. seems some of the inner lining catches on the edge of the well. have to pus that into the spave below the edge for the lid to close.
Datum: 07.05.2017
Betrachtungen: 4173
|
318_verdeck_5
Then the lid closes fine.
Datum: 07.05.2017
Betrachtungen: 4051
|
|
318_verdeck_6
Closing the soft top works without a problem.
Datum: 07.05.2017
Betrachtungen: 4043
|
318_verdeck_7
I have choosen to omit the plastic tubes on the drives side and simply pull the tarp over the side of the car and weight it down instead. hopefully it still has enough air to dry out completely so that i can stitch the bad parts of the zipper and zip in t
Datum: 07.05.2017
Betrachtungen: 3666
|
kingston_32gb_fake
Datum: 08.05.2017
Betrachtungen: 2837
|
