[general]
version = 2
name = PLA_speed
definition = fdmprinter

[metadata]
quality_type = normal
type = quality_changes

[values]
adhesion_type = skirt
bottom_layers = 5
bottom_thickness = 0.8
brim_line_count = 4
cool_fan_speed_max = 100
cool_fan_speed_min = 45
infill_line_width = 0.7
infill_pattern = grid
infill_sparse_density = 15
layer_height = 0.15
layer_height_0 = 0.3
line_width = 0.64
material_bed_temperature = 55
material_diameter = 1.75
material_flow = 95
material_print_temperature = 205
outer_inset_first = True
prime_tower_size = 8.660254037844387
raft_base_line_spacing = 1.0
raft_base_line_width = 0.7
raft_interface_line_spacing = 1.0
raft_interface_line_width = 0.2
raft_interface_thickness = 0.2
raft_margin = 5
raft_surface_line_spacing = 1.0
retract_at_layer_change = True
retraction_amount = 5
retraction_combing = off
retraction_min_travel = 5
retraction_speed = 45
skirt_gap = 2
skirt_line_count = 5
speed_infill = 70
speed_print = 70
speed_topbottom = 50
speed_travel = 70
speed_travel_layer_0 = 70
speed_wall_0 = 50
speed_wall_x = 60
support_enable = False
support_infill_rate = 10
support_type = everywhere
support_xy_distance = 1.2
support_z_distance = 0.45
top_layers = 5
top_thickness = 0.8
wall_thickness = 0.8